Previous | Contents | Index | Next

Chapter 1: Introduction to PuTTY

PuTTY is a free SSH, Telnet, Rlogin, and SUPDUP client for Windows systems.

1.1 What are SSH, Telnet, Rlogin, and SUPDUP?

If you already know what SSH, Telnet, Rlogin, and SUPDUP are, you can safely skip on to the next section.

SSH, Telnet, Rlogin, and SUPDUP are four ways of doing the same thing: logging in to a multi-user computer from another computer, over a network.

Multi-user operating systems, typically of the Unix family (such as Linux, MacOS, and the BSD family), usually present a command-line interface to the user, much like the ‘Command Prompt’ or ‘MS-DOS Prompt’ in Windows. The system prints a prompt, and you type commands which the system will obey.

Using this type of interface, there is no need for you to be sitting at the same machine you are typing commands to. The commands, and responses, can be sent over a network, so you can sit at one computer and give commands to another one, or even to more than one.

SSH, Telnet, Rlogin, and SUPDUP are network protocols that allow you to do this. On the computer you sit at, you run a client, which makes a network connection to the other computer (the server). The network connection carries your keystrokes and commands from the client to the server, and carries the server's responses back to you.

These protocols can also be used for other types of keyboard-based interactive session. In particular, there are a lot of bulletin boards, talker systems and MUDs (Multi-User Dungeons) which support access using Telnet. There are even a few that support SSH.

You might want to use SSH, Telnet, Rlogin, or SUPDUP if:

You probably do not want to use SSH, Telnet, Rlogin, or SUPDUP if:

1.2 How do SSH, Telnet, Rlogin, and SUPDUP differ?

This list summarises some of the differences between SSH, Telnet, Rlogin, and SUPDUP.

The Internet is a hostile environment and security is everybody's responsibility. If you are connecting across the open Internet, then we recommend you use SSH. If the server you want to connect to doesn't support SSH, it might be worth trying to persuade the administrator to install it.

If your client and server are both behind the same (good) firewall, it is more likely to be safe to use Telnet, Rlogin, or SUPDUP, but we still recommend you use SSH.


If you want to provide feedback on this manual or on the PuTTY tools themselves, see the Feedback page.

[PuTTY release 0.76]